Connecting the workstation
Article number: 208295
Before connecting the workstation to the instrument, set up the workstation according to its accompanying instructions. Locate the workstation within three meters (ten feet) of the mass spectrometer.
Requirement: Use shielded network cables with the mass spectrometer to ensure compliance with FCC limits.
Connecting to the workstation
Note: Do not connect the workstation’s power supply cord until you complete the installation procedures in the previous sections.
To connect the workstation:
- Select the appropriate power cord for your location.
- Connect the female end of the power cord to the power port on the rear panel of the workstation.
Connecting the workstation to the power source
To connect the workstation to the power source:
Notice: Do not connect the workstation’s power supply cord until you complete the installation procedures in the previous sections.
- Select the appropriate power cord for your location.
- Connect the female end of the power cord to the power port on the rear panel of the workstation.