Connecting the camera for the DESI XS source
Article number: 208301
The camera for the DESI XS source is connected to the workstation PC by means of a USB converter.
Figure 1: Video output connection for DESI XS camera
|
|
|
To connect the camera to the workstation:
- Connect the coaxial cable between the video output connector on the instrument’s rear panel and the interface box.
- Connect the USB cable between the interface box and any free USB port on the workstation.
Installing the camera driver software
The workstation is supplied with camera-driver software pre-installed. However, if you re-install or reconfigure the workstation, you must re-install the software. If this is the case, then Windows presents the Found New Hardware Wizard when you connect the USB converter.
To install the camera driver software:
- In the Found New Hardware Wizard dialog box, prevent Windows from connecting to Windows Update by selecting No, not at this time.
- Click Next.
- Click Install from a list or specific location (Advanced).
- Click Next.
- Select Search for the best driver in these locations.
- Select Include this location in the search, and then, in MassLynx, browse to C:\MassLynx\USBCameraDriver.
- Click Next
- Click Finish.