What pressure is needed from the vacuum pump to get a typical flow rate used on Oasis µElution plates? - WKB125083
Article number: 125083
ENVIRONMENT
- Oasis µElution plates
ANSWER
The pressure required is different throughout the SPE protocol and varies depending on the viscosity of the samples.
ADDITIONAL INFORMATION
Load and wash steps might require lower pressure (roughly 5 psi) that would need to be adjusted to reach the target flow rate of one drop per second. The pressure at the elution step would be set higher to remove all the liquid from each well, and this will also vary depending on the vacuum pump system and the number of samples to be processed at one time.
For additional information, see What is the part number for the Waters 96-well plate vacuum manifold?
id125083,